I was wondering if its possible to specify different frequencies. for example i want to run a simulation that actually starts from 1Hz to 30MHz. but i would like to simulate few Frequencies from 1Hz to 1KHz (ndec=2) and then more from 1KHz to 1MHz(ndec=10). then from 1MHz to 30MHz(ndec=25). Is this possible in Fasthenry?
secondly, i was wondering why i cant see the discretisation i made. doesent fast henry show the discretisation?
quote: I was wondering if its possible to specify different frequencies. for example i want to run a simulation that actually starts from 1Hz to 30MHz. but i would like to simulate few Frequencies from 1Hz to 1KHz (ndec=2) and then more from 1KHz to 1MHz(ndec=10). then from 1MHz to 30MHz(ndec=25). Is this possible in Fasthenry?
You need more than one input file, with different .freq statements
quote: secondly, i was wondering why i cant see the discretisation i made. doesent fast henry show the discretisation?
I guess you are referring to the filaments. Neither FastHenry2 nor FastModel shows the filaments, because this would usually lead to a huge number of faces to be drawn.
frequency selection
Posted - Feb 04 2012 : 09:40:54
